When referring to the printout, check that the “Connection” indicates “Active” and that the SSID -Service Set Identifier (the name of your wireless network) indicates the correct name of your wireless network. The network information page will be printed. Press and hold the button until the white power lamp flashes 6 times and then release it.
Load a sheet of A4 or Letter-sized plain paper.ģ.
Make sure that your printer is turned on.Ģ. To confirm that your printer is successfully connected to your wireless network, you can print out the network settings of your printer if you wish:ġ. When the printer has successfully made a connection to your wireless network, the blue lamp will stop flashing and remain lit. The blue Wi-Fi lamp on the printer will continue to flash while searching for, or connecting to the access point. Make sure that this button starts to flash blue and then go to your access point and press the button within 2 minutes.įor exact details regarding pressing the WPS button, please refer to the access point manual. Press and hold the button on the front of the printer until the white power lamp flashes once, and then release it.ġ. Make sure that the printer is turned on.Ģ. Most WPS enabled access points use this protocol.ġ. Your network must be using the WPA (Wi-Fi Protected Access) or WPA2 security protocol. If the WPS push button is not available please use the instructions in the Standard Connection Method section. Please check with your device’s user guide for details.
0 kommentar(er)
